Recensioni dei clienti per VEVOR Troncatrice Circolare Elettrica a Taglio Freddo per Metallo Lama Diametro 35,5cm Angolazione tra 0-45° Potenza Nominale 2800W, Troncatrice Circolare Taglio Freddo Velocità a Vuoto 1200 giri/min

Die Säge ist für den Preis sehr gut. Besser wäre es natürlich wenn für Gehrungen die Säge geschwenkt werden könnte und nicht das Werkstück. Ist aber in dieser Preisklasse eher selten.

The device's workmanship isn't exactly top-notch, but it's a good saw for the price. The locking bolt for the chassis parts holder and the clamp adjustment were a bit rough to finish. However, with minor repairs this was not a big problem. When sawing, a fair amount of metal shavings fly around, so it's worth building a collector for them so you don't have to clean the entire workshop after sawing. Despite the protection, safety glasses are mandatory, as always when doing metal work. The motor seems to have a lot of power and the blade cuts black steel well. I've only sawed a few parts so I can't say anything about the durability of the blade. When sawing, the saw surprisingly does not resonate, but is solid and the handle is sturdy. The overall rating is good+ and the price is reasonable. I can recommend the product to others. Delivery to Finland was very fast and with reasonable shipping costs.

good product

Muy buena compra el disco aguanta muy bien tanto tubo como macizo. La máquina no se calienta y no hace chispas al cortar

Tämä tuote oli kyllä hinta- laatusuhteeltaan todella hyvä! Kovametalli palat kestivät koko projektin ajan.

Great value as it some job, it cut through a 160mm/ 6 1/2 inch by 75mm/ 3 inch rsj in less than 30 seconds you couldn't ask for more than that and the cut was square didn't vere off not like the abrasive wheel ones could. The base is about 2 mm folded steel which I was happy to see

Cheap and cheerful, but be very careful with the blade. I like the fact that the clamp pivots both + and - 45°

Works great, Good price

works good for the price. Not as accurate at 90 degrees as it could be but not too bad, does not cut thick material very good. even with that it does better than abrasive wheels

Works great for my needs. The only negative i have at this time is that 0° is a little off.