I installed this enclosure to house a VFD in a pellet mill…absolutely the berries in terms of keeping the dust and water out and providing a clean environment for VFD

I purchased the cabinet to house my EV charging cable on the exterior of the garage. The size is adequate to smoothly coil approximately 22 feet of 7/8” (22mm) EV charging cable. The stainless steel cabinet was flawlessly constructed with sturdy hinges, and it was easy to cut cable routing and 3.25 “ vent holes through it. I cut a notch in the bottom of the cabinet and finished the edges with car door edge trim to allow the cabinet door to be closed with the cable extending out. The charger itself is located inside the garage so I only needed to house the cable. The brushed finish is attractive and does not show finger prints or reflective glare. The back steel panel inside the cabinet had convenient and accessible mounting studs allowing me to remove the panel for flush mounting the cabinet from its interior, while attaching the hose saddle onto the panel, then remounted inside the cabinet. It has a polished look and appropriate for the installation on the exterior face of my home. A note of caution if living in a coastal environment, is I’ve noticed that even stainless steel can develop some amount of rust. For this reason I believe that it will be good practice to clean it thoroughly and apply paste wax occasionally as a deterrent.