Recensioni dei clienti per VEVOR Ventilatore di Scarico Motore 255W Estrattore d'Aria Condotto Industriale 254 mm Tubo di Scarico 5m Volume d'Aria 1720 CFM Ventilatore di Scarico per Estrarre Fumo Velocità 2830 giri/min

Schnell geliefert, Artikel wie beschrieben.

Fungerer som beskrevet, eneste minuset jeg har på den til nå er støynivået. Kunne også kanskje ha vært litt bedre feste for slangen, er nå en tråd som må knytes.

Usato in modo continuativo per 8 ore da 1 settimana. silenzioso e senza vibrazioni. Per ora valuto ottimo acquisto. Spero duri nel tempo.

Products IS great but allso noizy but anyway at the workshop IS LOT of noizy stuffs ... But it's fast to assembly abs smells and novely Blow smela from weding out of workshop

A voir dans le temps. Modèle 255w Fonctionne bien , bon débit pour mon usage. Acheté pour évacuer les poussières et fumées de soudage dans un Atelier en sous sol . Selon le placement , évacuation variable. N'empêche pas la pièce d'être polluée mais permet de retrouver une atmosphère respirable en 5-10 min. Plutôt satisfait. Un bémol à noter : Un contre-courant est présent en périphérie du ventilateur. En clair , si on jette de la poussière au dessus de l'entrée , elle part dans l'autre sens ! Le flux n'est pas optimisé donc.

This turned out to be a good purchase. The fan feature works well,, the noise level is right at tolerable if you’re running it in the same location that you’re working in and the room size is a conventional room in a residence. If you’re running the fan on the opposite side of an exterior wall, it’s obviously more tolerable. As far as features, it’s hard to rate higher than a four, because there aren’t any features beyond the on/off switch and the GFCI reset switch. The fan draws enough air to clear smoke and Sheetrock dust effectively, as long as you’re providing enough air for it to move out. The fan is only set up to pull air at the end of the ventilation tubing and NOT PUSH IT, but I did have to utilize it as a push because of environmental circumstances and it performed ok as well with no detectable added strain to the motor. You just need to ensure that you tie the tubing to the fan casing well, because it’s not flanged like the intake, but it does have a rolled edge. I also secured around the guard for the trigger just to be certain it didn’t work itself free and blow the tubing through a window or something. The fan seems to be built well, but there’s not a whole lot of building involved. The casing is steel with rolled edges, intake is flared to connect tubing, functional GFCI switch inline, orange paint that helps with visibility, an on/off switch, removable steel grates on either end to facilitate cleaning and any maintenance or necessary repair, thick plastic fan blade and rubber feet for traction. You should be sure to clean as necessary, especially when you have it moving dust or things of that nature, and I had an old nylon bag that wasn’t being used to throw the tubing into, as well as a small leather belt that I got to run through the tubing and latch to make it easier to carry with the fan. Fan weighs 26.2 lbs carry weight total as I have it set up to travel, and depending on what I’m using it for, I usually keep a 13 gallon trash bag as well to put the vent tubing into until I can get home and rinse out any dust that may have accumulated inside.

Should have bought a bigger one or just get a regular fan,this was too small to clear paint fumes

Motor has one speed and not as powerfull as I thought it would be but still does its job

Only the invoice is complicated, add a VAT number is not so logical, but we will get used to it.

Article conforme à ma recherche, aspire bien les poussières que se soit une petite ou grande pièces. Je recommande vivement.