Recensioni dei clienti per VEVOR Vaschetta di Scarico Olio Serbatoio di Scarico Olio da 15 Galloni, Vaschetta di Scarico Olio a Basso Profilo da 57 Litri, Vaschetta per Cambio Olio di Grande capacità, Pieghevole a Mano, con Pom

Works good and low profile to fit under my semi truck. Had to put better hose clamps on from pan to pump and had to seal hand pump with a bit of rtv, it would weep abit when using and sitting onder shelf. All in all great purchase.

Looks like the pictures haven't used it yet but I don't see why it won't work. Pump looks OK as well

Works good with all my equipment for oil changes, I had a bad experience with a oil change they did not have the oil drain plug tight on my truck, ever since than I do my own oil changes on all my trucks and equipment.

PRODUCT ARRIVED QUICKER THAN I THOUGHT AND OIL CATCH PAN WAS VERY NICE QUAILTY AND WORKS AS SHOULD WAS VERY EAZY TO ASSEMBLE WOULD BUY AGAIN .

Use this for my tractors Maintenace intervals due to the volume of fluids needed to be changed. The directions could be better, I installed the manual pump upside down where the crank handle would not turn. Overall, it does the job.

Nice unit works as it should..needed a solution that didn’t involve using a 5 gallon bucket…works well to put oil into containers for transport

The price on this Oil Drain Pan was great and the product arrived within a few days without shipping costs. Very impressed.

It was perfect for me fit right under my international eagle I had no oil spill was easy to pump oil out back into old jugs great item

outil très pratique dommage que le tuyau de vidange soit trop court et il manquait les vis support de la pompe à part ça tout va bien

To start with, this is listed as a 15 gallon container... it is not! With 10 gallons in it, you cannot move it without oil sloshing out. Do not try to move it, just pump it out in place. The hose clamps they send are a joke. Don't dare use them. I use a wire clamper or sench tool I made. The hoses fit very loosely on the nipples and you have to squeeze them on tightly. 10 gallons of oil all over the ground would be a mess. It's not worth taking a chance. Also, Why do the Chinese not know how to make tapered pipe thread? You have to use about 6 to 8 times as much thread tape as you normally would to get these to seal, which they don't do until the fitting bottoms out. My modification to simplify the process, was to drill out a large nut with a 13/16 drill bit to fit over the shaft and put in a set screw in it. Then I weld a smaller nut om the front of that so I can put a socket and drill on to run the pump. I'm way too lazy to turn the handle by hand that many times.