Recensioni dei clienti per VEVOR Tettoia per Porta d'Ingresso 96,5x297,5 cm, Pensilina per Porta Esterna in Policarbonato Trasparente, Tettoia per Finestre UPF50+ Copertura Tettoia per Porte Finestre Antipioggia Impermeabile

The 91.5 cm measurement is wrong ??????????????????????????????????????????????????????????????????

I will give this a mostly respectable review because once it is assembled, it appears structurally sound, and looks good. Price is excellent. BUT, assembling it isn't easy. Once the two-piece corrugated canopy top is assembled (which is pretty easy to do), you need to thread it into the narrow grooves in the side braces. That's hard. Takes a lot of fiddling and jiggling with two people. Also, the tiny screws (Phillips head) that are supposed to anchor it all together on the four corners are tricky to get into the holes in the side braces, because those holes are down at the bottom of a cavities that are deeper than the screws are long. So you need to hold the screws with a tweezers or needlenose pliers to get them seated properly. They match up with the holes in the side braces only roughly, so screwing them all the way in takes a lot of force. Misaligned self-tapping. A small screwdriver won't do the job. Also the bars on the canopy top are identified as "front" and "rear" and, somewhat perplexingly, "rear" is on the outside edge of the canopy, and "front" is near the wall in the back. Duh? I'm an engineer, and the design of these is not particularly user-friendly.

Fast shipping. Awning assembled and installed easily. Quality looks good - will see how it holds up to Michigan snow loads sliding off roof above. I would revise to 5 stars if it survives winter.

We bought this August 27/26 and received it Sept 03/26. We're in Alberta so shipping was quick. Item was packaged well. I thought the mounting brackets would have been made of metal but instead they were plastic. A few screws they supplied were cheap and the heads stripped so I used my own. It took a while to get together but thanks to a few YouTube videos it was not so bad. I did most of it myself and my wife helped me with some. Mounting it wasn't too hard because it's fairly light but it did take two of us. Once it's mounted it looks nice, but my concern is, how it will hold up during some of the high winds and heavy snowfall we get in Alberta. Time will tell and update after a year or so. Would I buy this again? Right now I would say no, because in my opinion the mounting brackets should be made of metal and the plastic tinted sheets could be thicker. Over-all, it does looks good.

Was disappointed in delivery. Box was ripped open and there was some minor damage. I had purchased shipping protection, and after contacting that company - they told me I had to contact Vevor directly. What is the point of paying for extra shipping insurance when that company couldn’t even forward my claim to Vevor? I fixed the minor damage, and installation was not as hard as some others are claiming - just take your time and follow the instructions. I would have given it a higher rating, but after only a week or two, I can see where water has accumulated within the plastic sheeting. I don’t imagine this will last the winter. Lastly, I was sure the video I watched before ordering, showed the water pouring off each side, and NOT just off the end. There is NO eavestrough like piece on the bottom. NOTE: I never did contact Vevor directly once the shipping insurance company refused to look into my claim. DO NOT ORDER EXTRA INSURNCE - THEY WILL JUST REFER YOU BACK TO VEVOR - SCAM!

This is ok. But the wind will pop out the panels leaving gaps and rendering it useless.

Vevor has very poor customer service. Please avoid it if you can.

The wind blew one half of it off.

It could be better. It for the most part keeps the rain off of you. Was not easy to put together as it needed double the screws it came with. I am not sure it will last more than a year.

looks great but uses a joiner strip across the centre which leaks, the poly panels are just a tad short and I am going to put a tape across the entire centre to seal, would be much better if panels was in one piece.