Recensioni dei clienti per VEVOR Set di Filiere Maschi Utensili per Filettatura Misura Metrica M2-M18 110 Pezzi in Totale, Set per Rubinetti Matrici in Lega di Zinco Utensili per Filettature in Valigetta, Set Rubinetti Chiavi

Always using a tap or die. Bought because it was cheap. On opening it for the first time pieces fall right out and don't stay put. Only used once on a 1/4 20. No drill bit guide included. Good if your into cheap

I bought these and so far 4 have broken, the tap holders both get stuck and the taps aren’t held in very well, very poor quality,

I gave my ratings on this set based on receiving and viewing this set, I haven't physically used it yet, though if and when I do, I hope I can change my opinion.

Half the taps and dies Don't work due to the machining of them being very poor, m10x1.5 die doesn't even fit a m10x1.5 thread and noticed a bunch of them are juat poorly machined and don't work

A good range set for the money, if your a occasional user. The worst thing about it is the cheap plastic case. It doesn't hold the dies nor a good deal of the taps, so closing and opening is fraught with pieces flying all over the place. The tool handles are also cheap and loose their grip easily on the taps. Address those 2 shortcomings and it would score better

Does the job i needed it for

I just received this tap/die set. The taps are absolute junk with huge burrs on the leading edge of the flutes. If used, these taps would destroy a threaded hole. I didn’t expect real tool quality but expected that the taps would chase a thread. Do not buy these as they are by far the cheapest of the cheap.

I did residence this tools, but I have not used this jet.

I have only used some of the the die not the tap but they have been very bad, I was going to thread an M14x1.25 in tha lathe today but it wouldn't cut, It doesn't even work well to just clean the threads of an existing screw, It is just as hard to screw the die on as it is to unscrew, just as if it doesn't cut

I brought this set to excange the set I brought cheap here in Norway. But this seem Even cheaper. The holders for the bits are sad and flimsy and will probably brake fast...