Recensioni dei clienti per VEVOR Troncatrice Circolare Elettrica a Taglio Freddo per Metallo Lama Diametro 35,5cm Angolazione tra 0-45° Potenza Nominale 2800W, Troncatrice Circolare Taglio Freddo Velocità a Vuoto 1200 giri/min

The device's workmanship isn't exactly top-notch, but it's a good saw for the price. The locking bolt for the chassis parts holder and the clamp adjustment were a bit rough to finish. However, with minor repairs this was not a big problem. When sawing, a fair amount of metal shavings fly around, so it's worth building a collector for them so you don't have to clean the entire workshop after sawing. Despite the protection, safety glasses are mandatory, as always when doing metal work. The motor seems to have a lot of power and the blade cuts black steel well. I've only sawed a few parts so I can't say anything about the durability of the blade. When sawing, the saw surprisingly does not resonate, but is solid and the handle is sturdy. The overall rating is good+ and the price is reasonable. I can recommend the product to others. Delivery to Finland was very fast and with reasonable shipping costs.

good product

Muy buena compra el disco aguanta muy bien tanto tubo como macizo. La máquina no se calienta y no hace chispas al cortar

Tämä tuote oli kyllä hinta- laatusuhteeltaan todella hyvä! Kovametalli palat kestivät koko projektin ajan.

Great value as it some job, it cut through a 160mm/ 6 1/2 inch by 75mm/ 3 inch rsj in less than 30 seconds you couldn't ask for more than that and the cut was square didn't vere off not like the abrasive wheel ones could. The base is about 2 mm folded steel which I was happy to see

Compré tronzadora y mesa VEVOR. La mesa muy alta y más alta al colocar la tronzadora. La mesa sin cartelas para aguantar su escuadra, una tostada en el medio y ruedas que tiembla toda la mesa. La tronzadora : El primer corte corta con más o menos suavidad... Pero el trozo sobrante de unos 20 cm hizo un ruido como un petardo .. pegó en el techo y luego en el cristal de mi BMW rompiéndolo. Asustado. Lo dejo. al

The saw and blade make nice clean cuts, however making accurate cuts is painful at best. If all you want to do is make square cuts it might be okay. That said there are a number of massive issues. The base is not flat or sqaure to the blade. On my saw this is especially bad if trying make 45 degree cuts. To get the material sqaure to the blade there is a 5mm gap under the material at the blade. The other massive issue is that it is impossible to clamp the material at angles and it gets worse as the angle increases. At 45 degrees any amount of clamping pressure will cause the fence to rotate and change the angle

Kam beschädigt an und auch die Lager machen laute Geräusche. Keine Reaktion vom Kundenservice. Ganz schlechter Service und ganz miese Kommunikation!