Recensioni dei clienti per VEVOR Saldatrice TIG da 205 A con Ampio Display LED Lift TIG/MMA (Stick), Saldatrice Elettrica a Doppia Tensione 110 e 220 V, con Inverter IGBT, Avviamento a Caldo, Forza dell'Arco

Problem med att tända pinnen, när man väl lyckas tända pinnen så dör den precis som att amperen droppar för lågt. Produkten fungerar helt enkelt inte.

Fotpedalen till denna svetsen är digital av/på. Den saknar funktionen som behövs för att reglera ampere.

IF... IF this unit had foot amperage control, I'd be happy to say it would give the Miller and Lincoln lines a run for their money, really. Kinda cheap made, but lots of parameters to play with. The thing that socks is no fine average control at either a pedal (prefered) or torch slide. WHY WOULDN'T they build in a foot control??? It's aggravating to think about because it's so simple stupid kind of thing.

The machine looked ok. But as soon as it ignites ignites the rods it droppes in amperage an stops. Ot possible to use. Maybe a bad unit, I got the money back.

Got the 205A 2 in 1 welder. They claim it'll run 6010. It won't I've been trying to return it. They are giving me automated suggestions that are incorrect and don't work. Like running 6010 DCEN. 6010 is a DCEP rod. Don't buy.

Skrot, den fungerade tills jag skulle använda den! Den ville inte tända pinnen, tog upp svetsen och kollade så att kablar satt fast. När jag sen ställde ner den så blixtrade i svetsen och säkringen i garaget gick sönder, bytte den men svetsen är död! Skrot!

Seemed ok at first, looked ok at first, found that gas was not being released through the torch head, found the torch head gas line plugged up with valcanised rubber, once cleared out the primary function of Tig welding seemed ok, post flow doesn't seem to work, and the up and down slope doesn't seem to work, I compared settings to another known good Tig welder and got completely different results, so in short, does it work, yes, but not well, save your money, buy a better machine

Bonjour, Le matériel acheté est de bonne qualité. En revanche, la livraison a été mensongère et non conforme. J’ai d’autres articles à commander, mais au vu de cette expérience, je préfère envisager un autre marchand. Lorsque vous aurez changé de transporteur, car celui ci n’est pas correct, je reviendrai volontiers acheter chez vous. Cordialement Dominique

Tried this out today and on 110 volts it’s very inconsistent welds about 1/4” then stops. Tried it on 220 volts and it will run just over an inch of weld and just stops. I have a ticket in for a refund even bought the insurance and they want video’s little hard to do by yourself.

Received and after a few weeks I finally got some Argon to try it out. Unfortunately it did not work. Contacted support and they tried but could not find a solution so was partially refunded and will toss the machine out and try another brand.