Recensioni dei clienti per VEVOR Pialla a Spessore, a Due Lame, 330 mm Larghezza, Banco Elettrica Motore da 1800 W e 23500 Giri/min, Doppi Rulli, Protezione Eccessiva, a Velocità Singola, per Legno Duro e Tenero

Contacted the customer service first in two ways, and I gave them one week to reply; nothing so far, so I must come out with the negative review. Firstly, I also ordered the three-blade version with two speeds 5 days ago, but it hasn't yet arrived. - This Spiral-Style Cutterhead is an absolute abomination. The finish that comes from this doesn't change if you try to swap the blades or reinstall them. Also, they can be turned around only once, with two cutting edges, not four, and they don't sell new blades, and they are made of the same steel, so it will increase the cost of a full change in comparison to a 2-3 blade one. This finish is worse than any normal 2-3 blade machine could give; it also chips against the grain the same way as "normal" blades. Leveling the table 100% isn't possible, so for anti-snipe, you must build your own base from MDF/plywood that is 100% flat, which will eat 20-35mm of height capacity. Same for most tabletop planers, some have a better quality base to calibrate flat. Waiting to get my return information and money back. So far, no reply. Previously, customer service was prompt when I had an issue, and it was solved immediately. Oak board on the picture, did the same with pine, and sanding double the normal with Festool won't fix this even.

When the Wood plate is rough the machine pulls the plate but when the plate is smooth it can't pull (it starts to slip)

On my first use the machine left linear grooves where some of the blades went deeper and some more superficial - required a great deal of sanding. The company has NO ACCESSIBLE CUSTOMER SERVICE. Technical support has no clue where I can get replacement blades for when these blades wear out.. i WILL NOT BUY FROM VEVOR AGAIN

Tried to use this thing. Cutting head makes and awful sound when lowering with the crank and couldn't even lower past 1 inch to plane boards. Assuming it's a manufacturing error. Cuts well though for the price though unfortunately can't use because of the poor crank.

The cheapest Chinese technology!!! What 24,000 rpm, it has a brushed motor, judging by the sound, the maximum is 4,000 rpm!!! Some of the stickers are missing, the markings that are there are barely visible without a flashlight!!! and most importantly, there is not even a return link, now I will have to figure out how to return this piece of crap!!! To spend almost 350 euros on this Chinese crap!!!

YOU GUYS ARE HORRIBLE. You haven't even started to resolve my issue. you can just cancel my request. i will not be buying from Vevor ever again. My husband had to basically open the machine and fix the wires!!!! what is the point buying a $326 NEW machine if i have to open it and fix it!!!!!!!!!!!!!!!!!!!!!!!! so dumb. thanks for nothing.