Recensioni dei clienti per VEVOR Affilatrice per Punte da Trapano, MR-13A 3-13mm, Affilatrice per Punte da Trapano Regolabile con Angolo di Punta da 95° a 135° 11 Pinze, Ruota CBN e SDC

This has worked very well for my needs. I struggle with the smaller bits by hand, I lost my sight recently, so this is helping a lot. I did find it finicky at first, the setting dial to set the drill up is not matching the size of the bit. Now I just leave it where it is ... which is halfway, pull the bit out and make sure it's level with the flats on the holder. I also had to adjust the in and out of the thinning / splitting on top. Once I did that, it's been perfect. The instructions are poor, but there are enough videos to get you started. I probably should have bought the larger grinder. I have not used the diamond yet, the CBN is perfect for HSS. None of my carbide drills have been sharpened yet.

Fungerar bra och enkelt att använda.👍

Works great

- Leider gibt es bei VEVOR keine Ersatzschleifscheiben. Grosses MINUS! - Gerät robust und zufriedenstellend - Motorleistung für grössere Bohrer etwas schwach - Kleine kurze Bohrer unter 4mm sind schwierig einzustellen - Lieferung in die Schweiz + CHF 26.- DHL + Zoll

Machines works great and have no complaints on it. Directions could be a lot better for some people that haven’t used a machine like this.

Seems to be a quality machine. I have not used it but one time to just check it out. One thing that surprised me was Vevor charged me a transaction fee for using Paypal in the amount of $7.52 along with the price of the machine.

The machine works and performs fine, and is not too difficult to use. However, the storage area for all the collets is very poorly designed - not only is there no latch on the door that overs the storage compartment, there is also no way to keep the collets in their holes and they can just fall out at any time.

Works ok but would be nice that ability to sharpen even larger drill bits. I'm not convinced on the angle gauge precision.

Did have lots of bad drill bits, did sharpen all of them and they are SHARP. i think did done about 40-50 and no wear/tear seen. VERY resonable price to get more life for ok drills

Machine pas mal mieux que les modèles en plastique mais aucune notice en français. il faut tester pour comprendre. livrer avec deux meules CBN et SDC je sais pas ce que ça veut dire et rien n'est expliquer. sinon marche bien.