Recensioni dei clienti per VEVOR Motosega a Benzina Guidacatena 30,5 cm Senza Fili 25,4CC 1,2HP, Troncatrice per Taglio di Rami di Alberi, Potatura di Alberi, Disboscamento, Taglio Forestale, Giardini, Troncatrice Giardinaggio

This thing stinks. It's brand new and won't start. Support won't help. They have the worst support I have seen. I diagnosed it down to the point that gas is not reaching the cylinder. I tell them that but they don't respond.

Ne démarre pas

En panne rapidement et impossible d'obtenir un remboursement ou une étiquette de retour. Communication très difficile avec IA. Ma tranconneuse ne démarre plus et on me demande une photo du problème.... A fuir!

I never received

Price of shit...used it twice and it broke down. I need it replaced or I want my money back. David Merrill

Never got the 12” too start. Has never reaches the primer bulb no matter how much you pushed bulb in but you can hear air moving when push bulb in. The 20” fired right up no problem.

Bonne machine dans l'ensemble si ce n'est que le système de blocage de chaine est à demi fondu. Quasiment impossible à démarrer à chaud. Machine puissante mais le démarrage à chaud est un vrai handicape. Pas trouvé de position spécifique pour le démarrage à chaud comme indiqué dans le descriptif de vente

Tras cortar varios carros de leña se ha dañado el espadín, llevo años utilizando motosierra y quería uno de bajo coste para emergencias y tras cortar varios carros de leña, unos 2500kg de leña el estadin se ha dañado, queria saber si tiene reemplazo por garantía

I bought this small saw to keep in my tractor. So far this saw has worked good. It’s too early to give a better review but for the money it’s a good buy.

I received this product last night and upon opening saw a residue all over the unit. I thought nothing of it and continue unpacking. I noticed fuel in the primer bulb which was a first for me with a new chainsaw purchase. After putting the saw together which went fairly well, I topped off the bar chain oil and fuel. Tightened up the caps and set the saw up right. Instantly the fuel began dripping out. I put the saw on its side to further evaluate. I opened and closed a few to see if there was any obvious compromises but didn’t notice anything blatant. I primed the unit and ran for a bit. Started up and sounded great. The saw was left in upright position over night and the next more my towel underneath was soaked in fuel. Photos were taken of where bubbling was actually found when closing the fuel cap. Not thrilled about this at all. I also noticed I paid a few bucks more than I see advised on all social media platforms.