Recensioni dei clienti per VEVOR Macchina Spellacavi Manuale Diametro Fili tra 1,5-30 mm, Utensile Spellafili per Cavi in Rame, Modalità a Manovella o Trapano, Macchina Spellacavi per Telaio Q235 per Cavi

Great just is hard to change blade out. I mean really unnecessarily difficult. But everything else is good

Doesn’t cut smaller wire as easy but does a good job with the thicker wire?

Very good price and quality,easy to use once you figure out the angles of feed of the wire.

Great price for a well constructed sturdy wire casing stripper. Hard to get correct depth for initial cut, but once set it does a great quick job of cutting to strip casing.

It was a little hard to get the hang of at first, but is pretty simple to use once you get a rhythm going. I have only used it with a drill, which is a great feature. The hand-crank is only usable if you mount it to the edge of a table, otherwise the crank arm itself will hit whatever it's mounted to. The blade also comes loose really easily and veers off-center, which causes the wire to slip off the track. Despite those things, it's great for the price and I have been able to strip a ton of wire pretty quickly.

Pretty good but the blade in mine is slightly misaligned which does make it not work very well unless I guide the wire through. So I can just start it and go I have to guide the wire the whole time but still faster than by hand.

Worked as intended. I did notice the cutting wheel did come in contact with adjustment screw. This intern dulled the cutting wheel. I did try adjust the unit to minimize this contact. But otherwise the wire stripping went much fast with this unit.

Great stripper!! Well worth the money, the 8amp fuse should be replaced with a circuit breaker fuse style. Stripping bigger and longer wire lengths the machine bound up when the wire twisted and blew the fuse. All good until youre out of fuses.

Does an ok job of stripping the wire casing. Just have to be very careful to not got too far and cut into a section you are trying to save. Could use a revision on wire feed rollers.

I bought this to try it out since the price was reasonable. It works, although it takes some time to adjust the pressure to keep the wire centered on the cutting wheel. I have used it with a drill motor and with the hand crank. The hand crank works better because you can control the speed better. This is not the tool to use if you’re planning to strip 1,000’s of feet of wire. This is more to use while you’re killing time watching sports or just sitting around. I may try a more advanced model but this will do for now.