Recensioni dei clienti per VEVOR Kit Estrattore per Carrozzeria 3KW, Stazione Saldatrice per Rimozione Ammaccature a Punti 6 Modalità di Saldatura, Kit di Strumento per Riparazione Ammaccature Carrozzeria per Auto Camion Moto

Appareil facile à utiliser malgré mon manque d'expérience. J'ai dû improviser pour l'utiliser car aucune notice explicative en français n'est fournie. Pourriez vous m'en faire parvenir une afin que je puisse l'exploiter au maximum de ses capacités ?

Appareil abordable, largement satisfaisant pour l'amateur que je suis (13 heures d'utilisation sans souci, reste à voire dans la durée). Attention le terme "soudeuse par point " est ambigüe.

Bonjour, une étoile seulement pour l'utilisation car je ne l'ai pas encore essayé. Bon achat arrivé en bon état et dans les délais.Merci.

Components are good quality and solid. Nice build quality on the unit. A guide to explain the tools would be helpful eg: the Annealing rods. They are for softening metal to make it easy to rework. Search Spot weld puller on Trev’s Blog on YouTube for a great review of this unit and how he uses it. He’s a master metal worker. The heavy earth strap is a pain to use. Finding a position to attach it where it doesn’t cause panel damage or fall off mid job was impossible. Swap that for a clamp or magnet would be a much better solution. The auto/manual mode is not explained and works only randomly. In auto, the puller should energize automatically but I found I have to switch the unit off completely when switching back to manual/trigger mode. The wavy tool and claw are great for pulling creases in panels where you don’t have access. I used it on a door where I couldn’t access the inside as it was too shallow but for areas where I had access, I got instantly pro results using a basic teardrop dolly and slapping file which cost less than $100 and will last forever whereas all electronics have a limited life. The single ended spot welding sounds like a nice idea but is not strong enough for welding two 0.8mm car panels together but might be ok for welding thin metal tabs on battery packs? Single sided spot welder cost thousands for a reason. Buy a two sided spot welder if that’s what you need or plug weld the panels instead. So, if you can’t get to the back of the panel, this will help get the panel to a better point using less filler but if you can, do what the pros do. Use a slapping file and dolly and be done with it!

Did work as advertised.. I'm trying to reture it for a model that meets my needs.

Quand tu te mais en contact avec la carrosserie sa accroche mal et pas assez de puissance pour coller sur la tôle Mauvaise investissement Je viens de refaire une tentative et a aboutir à rien sa m'énerve de pas pouvoir réparer ma carrosserie de mon jumper

This is a nice machine if you are working on newer cars with thin sheet metal. I tried to pull some small dents on a 91 and 72 Chevy, it would not get a good weld to pull with. I tried new tips, regrinding the area and every heat setting on the machine. It was so bad I almost sent it back. But then I tried it on a newer KIA and it worked fine. Not sure if the alloy in the metal is much different that it won’t weld correctly on older steel or truly what the problem is. On the older stuff I just use a old stud puller I have.

Gäret ist in unfuktionierenden Zustand geliefert? Käuferschutz bereits aktiviert.

Nu am primit produsul

Intento devolverlo pero no me dan etiqueta para devolverlo