Recensioni dei clienti per VEVOR Kit estrattore cuscinetti 14 pezzi, separatore cuscinetti 5T, kit rimozione cuscinetto pignone con ganasce da 50-70 mm 30-50 mm, separatore cuscinetti ed estrattore

👍

I had to modify the jaw to make it work in my application, and after the second use the threaded rod that holds the jaw snapped. Not a lot great to say about the product, but customer service was great. Vevor sent me a full refund after I shared photos of the failed part.

Denne er helt ok.

Used on smaller scooter engine, pullers a little large for small bearings, but managed to pull bearings from the crankshaft. The set is probably intended for larger engines.

Producto de calidad regular

Bolts bend and one broke off. I have to source some grade 8 bolts from my local hardware store to use on it. Maybe fix the bolt problem and it won't be a bad tool. All this while removing carrier bearings on a 8.8 axle. So no I didn't put to much on it.

Received bearing puller kit with damaged blow molded case. Very low quality I don’t have high hopes for damage free operation.

I bought this item to remove a wheel bearing from the hub. The kit arrived promptly and appeared solid. However, was not up to doing the job, bolts which should pull the jaws of the bearing separator plate are too soft and bent like bananas. I had to use other means to remove the bearing. I am going to buy some high tensile bolts to try next time. But I'm not sure how tough the metal used for the separator plates is.

L'utente non ha lasciato alcun commento scritto.

Purchased this to remove bearing on my driveshaft carrier bearing. Perfect fit looked like it would make it a breeze to get bearing off. But broke on first try. Material is just too soft not hardened.