Recensioni dei clienti per VEVOR Kit di Sterzo Idraulico Pompa per Motori Fuoribordo 2,5 Mpa 300 CV per Imbarcazione, Motore Singolo, con Pompa di Sterzo, Cilindro di Bloccaggio Bidirezionale, 141 mL, Tubi Flessibili da 8 m

excellently packaged. quality product. everything needed in the package.55555.when I do additional testing, I will know one hundred percent because everything is fine.

Ho scoperto che l'instillazione è stata molto semplice, ma il passaggio finale durante lo spurgo dell'aria è stato un po' problematico. Penso che una valvola (come le valvole sull'estremità del motore) al timone per chiudere il fluido e mantenere la testa sul livello del fluido sarebbe di grande aiuto

I found the instillation was very easy but the final step when bleeding the air out was a bit of trouble. I think a valve (like the valves on the motor end) at the helm to close off the fluid and keep a head on the fluid level would help a lot

Best thing that I have installed on my boat, just love it! I would recommend this hydraulic steering to anyone who has cable steering. The cost is less than half of Seastar/Baystar.

This is a one year review. Works just as a sea star would. No problems what so ever. Install was easy too.

Well worth the money shipping time was great and great value for the money.would definitely order from this website again.

Installed on 1710 g3 with Yamaha 90 love it take your time easy install wow what a difference it made

Everything fits perfect. Works flawless. Install was fairly easy. You'll have to be handy with basic tools. Be patient working the air out of the system, it'll take some time. Turn the wheel lock to lock and watch the air bubbles till they're gone. Make sure you leave enough hydraulic line to loop down and around. The ram moves with the lines side to side.

Had cable steering in my 2014 Frontier bay boat going to my 90 HP Yamaha. The cable was on its last legs so I ordered this Vevor hydraulic steering kit. There were a couple issues I had to deal with on the install to make it work, and none of the issues related to the hydraulic kit itself. When I tried to remove my steering wheel it was corroded onto the cable helm shaft.....this would have been a problem if not for a sawzall to cut the old shaft....I did try heating the shaft with a torch, but it was not coming off. Once I had the steering wheel off I used a socket and a couple sledge hammers to drive the old cut shaft out of the steering wheel. Now I only had to remove the old cable.....Oh rats! the bend at the transom wasn't going to allow that to be done easily so this time I took a pneumatic cutting wheel and cut the cable in two (sawzall would not cut the cable easily). Taped a cord onto the cable and pulled it out at the transom and used the cord to pull the new hydraulic line back through up to the console. Used some lube on the hydraulic line to make pulling it easier. I shortened the hydraulic lines and then put the included hydraulic fittings on......the directions weren't much help for anything else but for putting the hydraulic fittings onto the hose they were spot on......make sure you read that part...... The cylinder hookup to the motor itself went well, but beware: It can be attached to the motor upside down (ask me how I know) Bleeding the line was expensive (used Seastar fluid) I should have captured it into another clean container to strain and reuse but I did not (2 quarts at $30 per quart). Can now turn the steering wheel with one finger when it used to be both arms working hard with the old cable. Hoping to get some good use out of it without issue........

I have installed all types of hydraulic steering and this unit is identical to the major brands, even the box is the same just a blued out area where the big name should be. I installed on our work boat after the manual steering rod got stuck inside the tube. I'm impressed enough that I ordered one for my personal skiff.