Recensioni dei clienti per VEVOR Kit di Pressatura per Giunto Sferico 10 Pezzi in Valigetta da Garage Officina per Riparazione Veicoli in Materiale Acciaio al Carbonio per Auto 4WD, Kit Attrezzatura Giunti Sferici a Telaio C

Travail très bien ça facilite le travail de beaucoup d' être bien outiller Changer ball joint du haut Sierra 2018 (ce n' est pas lister sur le feuillet) seul ceux du bas sont lister mais ça fonctionne bien quand meme.

Den funkar som det är tänkt och underlättar verkligen bytet av spindelleder. Det sparar verkligen mycket med tid och den är helt klary värd sina pengar.

Works great was just as advertised. Everything I needed was included in the kit and it worked perfectly for my ball joint configuration shipping was fast as always Vevor did a good job

Very nice set up but would like to have some more angled cylinders for uneven areas what's strong enough to pull out the ball joints on a Jeep Wrangler not were in there pretty damn tight. it would be nice if they came with two sets of threaded rods that way when you're in tight areas you could use a smaller threaded rod instead of having to take apart more of a vehicle to get the press in there.

Bon rapport qualité prix satisfais dans l ensemble . VENOR fait le travail demandé

Has worked well for me. Mostly used it for u joint removal, maybe a couple different cups would be nice but overall, i recommend it. I am a casual user so it works for me

Did what it was supposed to do. Really save on this job.................

Hat gut Funktioniert

Used it on a Jeep Wrangler JK to swap out upper and lower ball bearing. Works fine.

Had to do a full front linkage replacement on a 2013 Ford F-150 XLT. Bought this to both press out and press in the lower Ball Joints. First one pressed out with a little heat, second one needed the to be started with a sledge, to overcome the rust ring, but as soon as it was flush, the next tap popped it out. Both new ball joints went in fairly easy. The only issue I had with this kit is the press adapter rings (there are 3) were almost too coarse in diameter to press my joints in, the medium one was too small, the larger one was half on the edge of the ball joint housing. After getting it to straddle that edge evenly, the press went well. It IS quite a comprehensive kit and I'll probably only use it one or twice, bought it because I wanted to make sure I had ALL the adapters I needed and I only needed 4 parts. It would also be nice if all of the plates and tubes had some identifying mark to match a part list, so you know what cars they go to. They do have a application list in the manual but it only applies to 2004 and below cars and trucks.