Recensioni dei clienti per VEVOR Forche per Pallet Lunghezza 149cm Capacità Carico Max. 1814 kg Larghezza Regolabile tra 495 - 915 mm, Coppia di Forche per Movimentazione Carico da Benne Trattori Minipala Escavatori in Acciaio

Was moving rafters and some how bent one of the blocks that tighten it down with my 35 hp tractor

I was disappointed when I got these. The pads used for the mounting screws are just nuts loosely threaded on. When you go to tighten them, the nuts spin on the screw and will move up. When you loosen, the nuts fall right off. Very cheap design. If you are putting the forks on one time and leaving them, it would be okay. But if you are constantly taking them on and off, it is a big deal.

It work

I tried these forks on the bucket of my tractor. They were very hard to tighten and grab the Steele of the bucket. Once tight, they became loose again.

Item came as pictured, when unboxes i seen the box profile was 3mm wall, i expected 5-6mm wall for the rated weight it should handle, i will be welding on some flat to the sides for extra strength. The first time i used them the bolts to tighten to the bucket bent due to the gap allowing too much movement. I again will need to modify the gap and update the bolt size. Nice idea for a product but in my opinion as standard only fit for very light use.

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I bought my forks about a month ago, when I received the box it was torn up and one of the yellow plates was missing. When I put it on the tractor, one of the screws was cross treaded and extremely hard to tighten. Other that that, quality is awesome and very well made. I would buy them again.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

If I had it to do all over I would bought the ones that are connected but I just welded a piece of pipe to mine. They serve there purpose but the will shift one you no matter how tight you get them.