Recensioni dei clienti per VEVOR Forche per Pallet Lunghezza 109cm Capacità Carico Max. 907 kg Larghezza Regolabile tra 495 - 915 mm, Coppia di Forche per Movimentazione Carico da Benne Trattori Minipala Escavatori in Acciaio

Die Palettengabel an sich ist echt super, aber beim Service gibt es große Probleme. Wenn man sich an den Service wendet bekommt man manchmal Nachrichten in Englisch und dann wieder in Deutsch und dann nicht einmal von der gleichen Person. Dies verursacht ein großes Durcheinander. Als Fazit: Die Palettengabel ist super, aber der Service ist ausbaufähig.

Price was lowered by $27 one week later should have waited to purchase this item and saved some money or maybe they could credit me on my account.

10/26 fourche 3 point. Ces Cat1 alors fait pour petit trateur. Assez solide. Mais les attache du bas son trop basse et ne dessans pas assez. Je doit le modifier! Kubota BX23S 2022

Prima aan gekomen .Alleen ontbreek er een pen voor de hefinrichting Jammer moet die gaan kopen hier op het drop hoop dat ze er een hebben

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate

I did t rate it hi because its not strong enough for my use. If you're just going to make straight pics its fine but it twists easily and comes apart easy. I will find a stronger one. I wasted my money on this one

The center bar broke right away other than that work well

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

It work