Recensioni dei clienti per VEVOR Estrattore Cuscinetti per Ingranaggi a 2/3 Ganasce Forza di Trazione max. 5 Tonnellate, Estrattore Idraulico Corsa di Asse 50 mm per Manutenzione Smontaggio Ingranaggi Pulegge da Officina Garage

Did what it was supposed to (Porsche Cayenne drive shaft out of hub) can't ask more. Obviously a bit heavy but presume need's to be to cope with the work expected of it.

Billig og kraftig avdrager. God kvalitet!

I have a 2004 infinti Qx56 I use as my work truck. My front wheel bearing would just not separate from my CV axle. I sprayed hammered it for over an hour with a sledge hammer. So I gave in and asked my mechanic to come over so he had a bigger sledge hammer and we torched the crap out of it and tried every trick in the book, even reversing the bolts. We finally gave up and just removed the spindle and entire axle cause it ended up that the cv had also worn out. So he brings the parts to his shop puts it on his 20 ton press while torching and it still did not work. I had ordered this gear puller before I called my mechanic but he had showed up before it arrived. So a couple days later the puller arrived and I went back to grab the stuck parts, my mechanic said he doesn't think it will works if his big press won't work. He put so much pressure on the axle it bent the rod. Well I brought it back home put some more penatrant on it, heating for a while then I setup up the puller and it popped it off in less than 20 mins. It was so load it sounded like a gunshot. Remember these puts have not been changed in over 20 yrs and I live in rural Ontario, so you know it was super rusted.

powerfull tool.

estrattore potente :usato per estrarre i cuscinetti di un cilindro porta martelli di una vecchia trinciatrice agricola. Senza sforzo alcuno . veramente soddisfatto .

Très bon outil , facile à utiliser. Peut-être un peu lourd . Fait très bien sont travail. Il m’a permis d’arracher des tambours de freins.

This works great for removing rusted on brake rotors. If you are not going to save the rotors your could use a big hammer and beat them off but if you want to save the rotors and not leave marks all over them- this is the tool to use.

Works as described. Will recommend ro friends. Fast shipping, and great price.

Have to often remove bearings from electric motors and pumps, some of which are getting to be on the larger side, this pulls them off with no problem. Is a fairly chunky/weighty tool, but once adjusted and clamped on, you wont be holding it for long. Only annoyance is it comes without a storage box (the other version does for a few more £, but was out of stock when I needed it)

utrolig bra produkt og lett og bruke, anbefales på det sterkeste.fordelaktig pris . løp og kjøp, kan også brukes med to armer eller tre armer...................................................' Supert produkt. :D :D