Recensioni dei clienti per VEVOR Cric Sollevatore per Tosaerba, Capacità 399,1 kg, Cric di Manutenzione Telescopico con Manovella e Maniglia per Elettroutensili, Sollevatore Pieghevole per Trattorini da Giardino e Tosaerba Nero

Read specs carefully. Width is in Description but I neglected it, so it's about 1" short for my mower. OTOH, I telescoped a couple tubular steel over the bars so it could work (while yes voiding safety). As usual for Vevor, assembly instructions are minimal. First time I used it, the screw mechanism operated smoothly and it easily lifted my machine. On subsequent uses the screw has worked much rougher.

This lift was not big enough for my mower . If it was 6” wider it would’ve been much easier for me to use.

On pikkuusen rimpula..mutta nostaa konehen,ja saa tehtyä. Ei varmaan iän ase oo , mutta tuosta saa kyllä paranneltua. ihan rahan väärti kyllä

The lawn mower Jack is a bit flimsy but it gets the job done.

The product is okay. But I think it could be better built with heavier materials for what the application is for The wheel stop should be made higher. When I raised my mower up the wheel went over the wheel stop.

Seemed tippy at first. It’s gotta be man handled but seems to hold up ok.

Putting this together looked promising. However, the main part that would be holding the weight was poorly welded and not even welded straight so the part would fit properly. I could continue to put the item together and will now get my money back.

bonjour, la commande est bien arrivée mais l'appareil etait tordu au niveau d'une des équerres support de roue sans pour autant que l'emballage soit altéré. cela ne l'empeche pas de fonctionner et d'etre efficace. Juste sommage pour une premiere experience.

It is a cheap way to lift your mower up to get to the blades without removing the deck, works good for a riding mower but is a little unbalanced and sketchy with my zero turn. If the legs were wider in the front it would be okay. The locking mechanism is a nice feature incase the hydraulic jack bleeds off. The handle does not fit the release on the jack very well, definitely a cheap made tool but it works.

AS I WAS PUTTING THE LIFT TOGETHER THE ROD FOR THE WHEELS DID NOT LINE UP WITH THE FRAME HOLES. HAD TO BEND THE FRAME SO IT WOULD LINE UP WITH THE WHEELS. MY BIGGEST DISAPPOINT IS THAT IT IS NOT WIDE ENOUGH FOR MY 72 INCH MOWING DECK AND I DON'T SEE HOW IT COULD BE ADJUSTED TO MAKE IT FIT.