Recensioni dei clienti per VEVOR Compressore ad Alta Pressione Compressore d'Aria ad Alta Pressione 4500 PSI/30 MPA da 1800 W 220 V per Carabina da Paintball, PCP, Bombola da Immersione con Scarico Automatico

Livré en 24 heures, fonctionnel +++, ce qu’il me fallait et aussi rapidement, je suis très content

Reçu, mais j'ai pas essayé

I made up an adapter fitting and use it to fill small CO2 tanks for drag cars - No issues

I bought this pump for my new PCP 17 air rifle. Works great pumps the tank up to 232 Bar in no time at all Cheers great pump.

Mauvaise description du produit. Arrêt automatique ne veut pas parler de protection thermique mais d'un pressotat réglable à la pression demandé.

Parfait pour remplir les bouteilles de paintball/airsoft

Using it for filling a PCP rifle. Works beautifully

Super fin og billig

Fast delivery. Work fine. Noisy. Good for price. Works fine for my pcp fx airgun.

hmm where do I start, its a very capable compressor there are a few things I dont like that much. Instead of the adjustable pressure stop known from other brands this compressor uses a safety valve that "should" open around 4500 PSI. It does that when I tested it with a plugged filter with the pressure raising very quickly. BUT once connected to a bottle, the pressure increases of course way way slower and because of that the safety valve does NOT open reliable, I was close to 4800PSI in the bottle already when I had to shut it off manually. So the valve works in a test scenario when you plug it and the pressure increases quickly but does not work reliable when you actually filling a bottle. Direct filling a PCP gun bottle is also not possible as you cannot set a pressure so you have to fill a bottle first and feed it from there to the PCP gun or you constantly stay close and stop the kompressor as soon you reach the needed pressure. You also need to cycle the pump with cheaper oil and no load like 4-5 times until the oil stays clean. Used expensive oil at first try and it turned black after like 10 minutes so make sure to clean it out first with cheap mineral oil and once its clean use the expensive synthetic one. It has an automatic temperature shutoff but it would be nice to also see the temperature as there are no displays on the device. Get a proper filter, best would be a 2 stage, the compressore creates a ton of water and the little filter it comes with will be soaked fully with oil and water after a single use! I upgraded the compressor feet with vibration dampeners as well a more capable waterpump with higher flow. Planing to build a closed loop with 2x240 Heat eschangers and 4 8k 120x30mm server fans.