Recensioni dei clienti per VEVOR Cesoia a Leva Lamiera, Taglierina da Banco Senza Gola, Forbici Manuale in Acciaio Dolce Calibro 16, Taglio Spessore Massimo 1,5 mm per Acciaio, Rame, Barre d'Armatura, Alluminio

I purchased this shear about a month ago. It doesn't cut my metal properly; in fact, it starts cutting in the middle of the blade rather than at the beginning where the top and bottom of the blades meet. Additionally, it has only a metric measuring ruler instead of having both millimeters and inches. The blade guard is cumbersome to attach and the screw holes don't line up properly. I've contacted VEVOR about this issue and have yet to get a solution other than to tell me to start cutting at the beginning of the blade, which clearly doesn't work. I've been waiting two weeks for an answer to my issue but just keep getting the runaround. I've used guillotine shears for years and have never had an issue like this. I'm very disappoin ted in both the product and customer service.

Product never arrived. Lost in transit.

Esto es una estafa he pedido. La maquina. Dos ves la primera se perdió he esperado mas de 15 días para la otra Me he puesto en contanto con varios agentes y ninguno ha podido dar una explicación La ultima agente sr elena me trato como sin importancia despidiéndose con que me lo reembolsa y ya sin darme una solución adiós y fuera Soy un cliente de vevor y siempre con mis compañeros de trabajo he hecho publicidad de una empresa seria donde comprar ahora no entiendo que ha pasado

Pessimo articolo, sicuramente dal prezzo cosi contenuto l avrei dovuto capire fin da subito, tuttavia avevo necessità di una taglierina e questa era l unica disponibile in pochi giorni. E' praticamente inutilizzabile, oltre ad essere vecchia, si percepisce dallo stato di usura della vernice che sia stata prodotta qualche anno fa e conservata male in deposito. Presenta un errore tecnico che è rappresentato da uno "scalino", che rende impossibile un taglio non sbeccato. Non trovo quale altro utilizzo se ne possa fare, di certo non taglia fogli di allumino neanche di 4/10 di spessore (poco più di un foglio di carta. Sconsigliatissimo

Does not want to cut sheet metal it slips a lot

unit will not cut seems the cutter are not aligned properly. I'm requesting a refund.

after about 4 hours of fixing the shear it works good, all bearing holes were stamped out not round . i had to round holes add bearings now it works good . i call this a kit shear

The description says it will cut steel to .08 (80 thousandths) thick, which is 14 gauge steel. I am using a lot of 16ga HOT ROLLED steel, and it will not cut it. I have had to resort to using a plasma cutter or friction blade and trimming/finishing. To see what it would cut, I cut some 20gauge aluminum sheet just fine, as well as some 20gauge hot rolled steel. Even cold-rolled steel at 18 gauge would not cut. So, since I bought this to do 16 gauge steel, its a big disappointment. But I do a lot of circuit board work and it cuts FR4 easily so I'll keep it for that. One reviewer says he uses it to cut 12Gauge steel, I dont see how.

seems to to be okay on the thinner metals, haven't given it much of a workout yet.

the shear is ok but very hard to use on flat bar