Recensioni dei clienti per VEVOR Cavalletto per Moto Ruote Capacità Carico Max. 816,5 kg Supporto per Ruote di Moto Diametro da 381-558,8mm Larghezza 76,2-203,2 mm, Cavalletto per Moto in Acciaio per Fissare su Camion Rimorchio

Worked well to support a HD Fatboy in a 6x12 U-haul trailer for 1700+ miles. Tied the fork lowers down to the bar on the stand. Also tied down handlebars to the D-rings for some additional safety measures. Problem came when trying to pull the bike back out of the cradle. Would have worked better if I could have screwed down the stand to the trailer deck, but its a rental. Conversely my CBR600 pulled out of the cradle with no issues, roughly same weight (older bike), so tire diameter, weight distro and all affect the ease of pulling it out.

Good Quality material and ver stable. My 430kg bike pushes the stand away instead of rolling into the stand. delivery took 5 days longer than Promised and picked it up from depot otherwise I would have waited another 2-3 days

When you load a motorcycle too much free space on the Axe central front wheel is going left and right approximately 1cm Too heavy 15kg Too big Too expensive for that tand

This chock is well made and a bargain for the price. It makes for a safe and steady brace while you work on your bike.

Questo bloccaruota è di buona qualità costruttiva. Non c'erano istruzioni incluse e l'hardware era sciolto nella scatola. Ho dovuto cercare dadi, bulloni, perni e rondelle. Sono andato insieme senza istruzioni quindi forse non era necessario. Non ho avuto problemi nel montaggio. Ho dovuto posizionare un sottile pezzo di legno appena prima e subito dopo il supporto ruota rotante per sostenere il peso di una Harley Davidson da turismo (900+/- libbre). Tutto sommato, sono soddisfatto; è stabile e si sente sicuro anche senza fissarlo. Tuttavia, la sicurezza prima di tutto!

This wheel chock is of good build quality. There were no instructions included and the hardware was loose in the box. I had to scrounge for nuts bolts pins and washers. I did go together without instructions so maybe not needed. I did not have problems in assembly. I did have to place a thin piece of wood just before and just after the rotating wheel holder to accommodate the weight of a touring Harley Davidson (900+/- lbs.) All in all, I'm satisfied; its stable and it feels secure even without strapping it down. However, safety first!

Bon matériel assez lourd donc assez robuste, par contre dommage que le réglage ne se fasse pas sur la cale arrière.

Reçu en temps et en heure mais arrive déjà abîmé avec manque de peinture et un peu piqué part la rouille donc decu

I have a 21", 90 width front wheel which is a little thin for this so doesn't hold the 250kg bike secure enough. I have a simple solution: kick down sidestand, put a little stone under it and done. No wind is strong enough to tip the bike like that. You can check it out on my youtube channel @onthepegs

Bon rapport qualité prix