Recensioni dei clienti per VEVOR Binario di Guida per Troncatrice Circolare Lunghezza Guida 700 mm Set 4 Guide in Alluminio 3 Connettori, Set di Guide per Seghe Circolari per Lavorazione del Legno per Fai-da-te Falegnameria

tracks they are very low quality. The edges do not line up square. The rubber edges and the red slides fall off the guides . The worst part is that due to incorrect square cut when all together it’s not a straight edge.

I’ve only had the tracks for a couple of weeks. Very dissatisfied with the quality. The rubber pads on the back of all of them have come loose. I would not recommend them.

les connecteurs ne sont tout à fait à dimension du rail alu, donc il y a du jeu. Une fois les connecteurs montés et serrés, difficile d'avoir un linéaire parfait. Dommage, c'est quand ce que l'on demande pour un guidage.

Bad product out of the box with rubber strip falling apart. Brand new useless product.

Ne glisse absolument pas avec une scie Makita. Il faut forcer comme un malade pour que la scie avance et attacher le guide.

Rail op zich is goed maar de rode kunstof glijstrippen laten los en moet je opnieuw vastzetten.

Glidskenor släpper och passformen när man sätter ihop dem är inte i nivå med andra tillverkare.

Does not cut straight . Do not recommend. It’s only good for small 24” cuts anything greater there’s alot of discrepancies.

L'objet est reçu bien emballé, aucun problème de ce côté-là. La qualité des assemblages métallique est là, par contre un gros problème sur les bandes rouges de glissement. La colle ne tient pas ! la scie plongeante ne glisse pas ! Je regrette simplement de pas avoir mis 30 € de plus pour un produit de qualité et fonctionnel. C'était ma première commande chez vevor. Je ne pense pas m'arrêter sur cette mauvaise expérience. A voir

Upon tracks arriving, straight out of the box the orange rubber strip on top and the splinter guard strip’s adhesive was debonded and falling off. Not to mention when putting 2 tracks together they don’t meet flush and cause the saw to get stuck while sliding. Contacted customer service to return them and to start with they only wanted to credit me $20 and told me to go buy some glue. When I said no they finally offered to exchange them or I could return for a refund, with a caveat though. Since the box they were shipped in had seen its better days I was expected to pay for packaging out of my own pocket and drive 40 miles to the closest FedEx facility to me. I have refused and am currently waiting for a reply. Before you say I’m being petty, remember vevor is trying to establish itself as competitive with other tool companies on the market, and good customer service goes a long way with this. So far I am woefully unimpressed with the product or customer service…