Recensioni dei clienti per VEVOR Attuatore lineare 12V, Attuatore lineare da 25,4cm 598,74kg/6000N, Attuatore di movimento lineare da 4,826mm/s con staffa di montaggio e protezione IP44 per porte elettriche navi da carico

Très bon produit bien emballé. Amélioration proposée : la description des interfaces mécaniques

A good, well made and also affordable product.

VEVOR has a very good reputation in my DIY Group - Quality, Price, Features

Prima product van goede kwaliteit. Ik had er al 1 in gebruik en dit is de 2e nadat we besloten hadden om ons handmechanisme te vervangen voor elektrisch. Gezien het gemak nu een 2e besteld. Snelle levering en goed verpakt en werkt zeer prettig, deze is niet snel maar prima in ons geval. De bevestiging beugels hadden een iets andere vorm mogen hebben van mij maar ze zijn op zich goed van kwaliteit.

Prodotto perfetto buonissimo qualità e prezzo.

Rien a dire de particulier, fait se dont pourquoi il est prévu, à voir la durée dans le temps

En vielä kokeillut, mutta tuskin rakenne kestää 600kg, ehkä 200kg. Muuten näyttää asialliselta tuotteelta

Good quality overall (some weak fittings & poor assembly on the linear slides). Superb delivery service!

Purchased this in the later half of July, 2026 and its used to push open the sleeper cabs shells. Ordered ten for five units. Usually arrives quickly and all parts are working and ready to go.

Amazing push. Replaced the hydraulic cylinder on a 1000 lb lift cart. Still lifts at least 300 lbs (which is the most I've tried). 11" to 33" in ~25 seconds. Running on a Ryobi 18v drill battery. The maximum draw I've seen is 11 amps. But only for a second when starting from the lowest table height. I replaced the 30 amp fuse included with the battery holder with a 10 amp and it hasn't blown. Runs about 6 at mid to max heights in up mode. Down is less than 3 in any position. I won't be using it below 20" and only for a few inches/seconds at a time. I'm sure it will tolerate the extra 6 volts for my use. If not, I'll replace it and find a 12v solution. The bushings that reduce the base clevis from 12mm to 10mm are soft plastic and one was split. I didn't need them. It's odd that the piston clevis is 10mm and the base is 12mm. The included brackets are thin bent sheet and I wouldn't use them at high load. They wouldn't work for me anyway. Works better than my expectation in both speed and lift. I'm guessing adding a second actuator will give >500 lb capacity.