Recensioni dei clienti per VEVOR Affilatrice per trapano Smerigliatrice per trapano da 120 W Stazione di affilatura a 4500 giri/min Affilatrice per trapano in acciaio 45# Angolo della punta regolabile 95-135° 18 pinze

Gute, massive und brauchbare Maschine für wenig Geld. Bei den kleineren Bohrern weicht die Einstellskala für eine genaue Ausrichtung etwas ab, aber man findet die richtige Einstellung schnell selber heraus. Kann sie weiterempehlen undvwürde sie wieder Kaufen.

L'outils est arrivé en bonne état , et complet ,facile à utiliser , le seul point négatif est la livraison ,j'ai attendu plusieurs semaines avant de recevoir ce colis , j'ai communiqué à 4 reprises et mon colis était toujours au même endroit sans bouger c'est décevant faut s'armer de patience Vevor

Affilatrice migliore di tutte quelle provate!! facile da usare. molto bello il fatto di poter regolare l'angolo di punta, la centratura dell'angolo di scarico invece è un pò macchinoso da eseguire e ad ogni diametro punta va regolata. per il resto tutto ok: materiali impiegati, doppia mola, motore silenzioso.

je m'attendais à mieux vu le prix élevé

Gute Maschine, macht zuverlässig was sie soll. Leider etwas zu teuer.

The grinder is good. That part is fine. The instructions are a bit lacking. I think the instructions are pretty generic, as there are several variations of this small drill grinder. This particular model, the MR20G has a bunch of adjustments that are not explained in the manual.

Works as promised

This is an amazing tool that's easy to use once you become familiar with it. It leaves you with a professional cut like it's a brand new bit and will save any shop that uses a lot bit a lot of money. I recommend watching one of the how-to video that are out there and learn with a old drill bit, as the instructions aren't great. This is why I gave 4 stars overall. Otherwise I love the tool.

Assez bon produit, manipulation facile

Very nice sharpener and all I need for my uses. Would be nice if it could sharpen to a bit smaller sized bits, but it covers most of what I use. Better instructions are really needed. The grammer is terrible. The worst part is the section describing the placement of the pins for different sized bits in the 2nd step for tip splitting. There should just be a table saying where to set them for different size ranges of bits. Basically, it's just trial and error now. But, sill way better then anything else for twice the price.