Recensioni dei clienti per VEVOR 2 pedane da 6,5" compatibili con Chevy Silverado/GMC Sierra 1500 Crew Cab 2007-2018/2019 2500HD 3500HD 1500 LD, 201 barre laterali in acciaio inossidabile, capacità di carico 500 libbre

Queste pedane sono facili da installare e si adattano perfettamente al Ram 1500. Hanno un aspetto diverso grazie alla cromatura a specchio. Funzionano bene e sostengono un bel po' di peso.

Bought these for a 2013 crew cab silverado, ( winter driven in Canada, no steps prior to this purchase) The 2 back mount on both sides are mounted with replacable inserts clip to bolt in, fairly easy to replace clips & put in new bolts that are included in, Beware, The fun part is the front. The factory holes for these are hard mounted into the rocker panel + inner rocker panel, with the accumulation of rust & calcium i snapped a few of the new hardware bolts that came with the steps, i had to drill & retap the holes for the new hardware to fit my situation Rusty installation issue asside, these side steps are very good Quality for the price, do remeber that you are paying 1/4 of the price than that of the GM OEM’S so they might not feel as sturdy as a real pair

Alight delection when stood on but still decent for the price.

I really like these running boards. I did not install so Im not sure about how well that went. I gave 4 stars because on the black step piece at the end, it is just slightly hoved which will allow water to lay under it with dirt and could cause a rust issue rather quickly. But I will assume it was just mine that had a slight flaw. I ve only run them for a few weeks so we'll see how long they stay shiny and pretty.

They are really good for the price. They are not a tube, they are a channel. I was replacing some chrome steps that the Crome was coming off. These are stainless steel so that will not ever happen again. However I would have paid an extra $100 if they were a tube. That why I could not give one more star.

Well packaged, with all required hardware. Once all the old running boards and mounts were removed (if this is your situation) install was a breeze and took about 45 minutes. Use of an impact drill or air ratchet is recommended. Quality appears to be a 3/5 - metal is a bit thinner than I hoped. Apperance - 5/5, looks sharp and is exactly as shown. Durability - 4/5, stands up well so far.

The nuts in the running board turned when tightening them and not using alot of force or over tightening

Bottom line: these are good, but you gotta take your time. The directions are not very detailed! Took me a whole day to get the first side on because I had to figure out what I was doing! You can do it by yourself, but you will need a car jack to hold it up while you tighten it in place! get everything set where you want it and then go back and LOCTITE EVERYTHING. If you do it the right way, you'll have a rugged set of running boards that don't wiggle, don't rattle, and don't sag. If you just bolt it up without a care in the world, the running boards will sit VERY low to the ground. The brackets themselves and the running boards are good quality! Idk if it'll hold 500lbs like it says, but I can get in and out, and reach the roof of the truck with any movement. I would post a photo, but the file size is too large.

One of the 6 holes of the rocker panel bolt pattern on the passenger side did not line up. That bolt up section of the running board was not square(slightly twisted). Poor quality control.

Fits great follow instructionmake sure brackets are in right order And things will go smooth easy installing 2021 dodge warlock