Recensioni dei clienti per VEVOR Supporto Telaio per Troncatrice Orizzontale Lunghezza Taglio Regolabile 355-914mm Spessore Regolabile tra 5,08-300mm, Supporto per Lavoro di Legno con Troncatrice da Esterno in Acciaio Zincato

schnelle Lieferung und für den preis recht stabile Konstruktion. Die ersten Meter bereits gesägt, ohne Probleme. Würde ich jederzeit wieder kaufen.

So far so good I'd buy it again put it together and got straight to work! 48" is nice works perfect with my 52 inch chainsaw guide bar

I replaced all bolts, washers and replaced the nuts with nylock. I need to trust a chainsaw bolted across my belly. The assembly instructions could have been better and even with the video it was quite alot to get right. Finally there was two mystery bolts where the chainsaw guide bar should be inserted and since i wanted to get it right i asked support. They arent that supportive.. and its been like two weeks already and i havent gotten a stright answer. The support dont seem to understand the mechanics of the sawmill AT ALL. I had to drop one star because of this. Never talk if you dont know what you are talking about, just ask someone smarter. Bottom line. This is a sweet deal compared to "the original" and that compensates for halfass support.

terribly built

Do not buy, I purchased this item and never received it. When i contacted vevor they said it takes up to 15 days to receive your refund. It's been over a month now and still no sawmill and no money. I would not purchase again.

Hyffsat stark men delvis svårstartad och drar endel bränsle

J'ai dû faire des modifs pour que ça fonctionne correctement et la visserie est moyenne

Be prepared to reinforce the tubes that clamp to your chainsaw bar. If you don't, and you tighten them enough to actually hold the mill together in use, you will bend the tubes and render the entire tool pretty useless in minutes. I pressed aluminum bar stock into the ends of all 4 clamp tubes and drilled clearance holes through for the bolts...and thing shave worked just fine through many dozens of oak slabs. The whole thing should have been built with beefier tubing, like the granberg stuff they tried to copy..... If you aren't handy enough or don't have time to reinforce this thing then you're just wasting your money. But if you can tune it up it will get you where you want to go.

Das genaue einstellen der Schnittbreite erfordert schon recht viel Zeit. DIe Skalen sind nicht wirklich zu gebrauchen. Aber es sind gerade Schnitte möglich.

Die Massangaben auf den Holmen für diehöheeinstellunhen sind in hier untypischen Inch, sehr unpraktisch, wenn man regelmäßig höhenvertellungen vornehmen muss/will, ist das Gerät ungeeignet, da viele Schrauben zu lösen sind, Werkzeug (auch China-Billigware) ist dafür nur 2-3 mal geeignet, dann überdreht, handling vollkommen unpraktisch. Schrauben nicht selbstsichernd