Recensioni dei clienti per VEVOR Morsa Precisione Morsa di Fresatura Fresatrice di Serraggio con Base Girevole a 360 Gradi, Apertura 125mm Forza di Serraggio max. 24 kn

Der Schraubstock besteht aus einem guten Material (vergüteter Stahl) und ist mechanisch gut verarbeitet. Der Planschliff ist ebenfalls gut. Gut einsetzbar für ein genaues Arbeiten. Preislich könnte er einen Ticken niedriger (in den 60ern) sein aber noch noch okay. Insgesamt Gut 👍

Arrived in good time, well packed and in good condition. The finish is excellent and it is easy to use.

Fin maskinstikke. Mye for pengene. Fungerer helt fint til mitt hobbybruk. Kjøpte først en. Anbefalte og kjøpte en til min bror også.

Very nicely built - good quality and not a lot of cleaning up before using. Accurate

O piesa solida si bine executata, funcționează ușor, fixează bine materialul la un preț bun, sunt multumit

calidad precio es perfecta para taladros de columna o pequeñas fresadoras..os la recomiendo

Very Nice for the Price! I don't use it every day. Home Shop use.

Superbra till priset

TL-DR: I'm overall satisfied because I expected that the price meant I was getting a fairly decent casting, machined and ground that requires further cleaning, deburring and refinement. The paint is very decent and overall surface finish more than decent. - Received promptly in good condition by pure luck since there is ZERO protection in the box. - No rust on mine*, only grime and machining swarf and some sticky oil/grease partially dry. - *Not everything is coated and in a cold climate, it got full of condensation. Unpack, degrease and clean and coat with WD-40 immediately.* All the immediately visible machined surfaces look good, but EVERYTHING needs cleaning and DEBURRING. A complete teardown shows some casting defects (minor) and not as good machining where it is "hidden", and more involved deburring and filing is needed to address that. ***The nut that sets the pressure against the thrust bearing for the lead screw has 2 set screws which damage the threads. - The bearing and leadscrew need to be cleaned and re greased. - Yes, one can use it out of the box, it works, but it will probably grind itself over time and even draw blood when handling. Conclusion: After a couple of hours of tearing down, cleaning, deburring, filing some casting excess, filing the damaged threads near the handle, some wire wheeling and polishing, a nice waxing of all the non moving surfaces and oiling and re-greasing the leadscrew+ Nut and bearing, it works flawlessly.

Ottimo prodotti