Recensioni dei clienti per VEVOR Gamba da Tavolo Nero, Gamba Tavolino e Scrivania in Acciaio Forma di X, Gamba per Tavolo in Metallo 720 x 790 mm con Capacità da 1000 kg per Tavolini, Divano, Mobile, Porta TV, Scrivania

The legs look great and were uniform. The legs once screwed to the table tended to wobble (about 46 inches apart), as other reviewers stated. The top plate should be wider with more screw holes on both sides would help with stability. I drilled these my self. I also installed 2" steel angle iron between the legs, attaching it inside the top V by drilling two sets of holes in each leg (one in the V and one on either flat - total of 3), on set on out edge of V and other on inside edge, for a total of 6 holes in the angle iron and each leg). I used self-tapping #14 screws, I pre-painted everything black. Came out nice and the table was rock solid.

It arrived with a few scratches, not well enough packaged, only one layercardboard as protection. Top plate little thin, one mm thicker would have been better. Otherwise nice.

Beine stark verkratzt und eingedelt, Schraublaschen fehlen jeweils an einer Ecke, so dass die Beine angeschraubt wackeln. Lieferung war schnell

Odnos cijene i kvalitete je prihvatljiv.

Top, mais les vis ne sont pas du tout adaptée

Nécessite un trou supplémentaire dans la partie à 45° pour pouvoir le visser au 4 coins. Car pas stable en l'état (bouge et grince).

Good solid construction. A little too high for table height with adjustable legs on so had to remove adjustments and set on floor direct

alles gut, ausgezeichneter Kauf, sehr schneller Versand, wir haben beim Kaufpreis gespart, gegenüber dem Geschäft, wo wir den Artikel gesehen hatten

Livré en tant et heure conforme a la commande Je recommande le site

The table legs are nice looking, great quality and good finish. I custom made a quartz table top for the table legs and used 3/4” plywood to fit inside underneath the table. I also added cross bar pieces of plywood to help support the table from shaking. It’s a lot better now but still shakes a bit. I have 2 suggestions (1) the seams in the table legs need to look seamless as I can see the welding joints at the X (2) the table is unstable even with extra supports (I have quite a bit of supports so it’s now okay but still shakes a bit). I suggest a cross bar at the joining of the X for proper support or at minimum provide the option to buy the support.